4WD 60mm Mecanum Wheel Robot Car Chassis Kit w/ MG513 Encoder Motor Arduino DIY. Speed: 1.2m/s (M / s). Base plate material: 4.5mm acrylic. Rated voltage of motor: 12V. Encoder: turn the wheel once, output 390 pulses (the tire can distinguish 0.23 ° rotation).
Note:the car without suspension uses acrylic base plate, which can make the wheels slightly adaptive if it is a little soft. The car without suspension can't use aluminum alloy because if aluminum alloy is used as a rigid plate, there will be a wheel hanging in the air at 3 point direction , and the running effect of the car is very bad.
4 x 60mm Mecanum wheels. 4 x 12V DC motors with MG513 encoder.
Not included any controller and battery. Unassembled kit, please leave your mailbox to get the installation manual. Usually it cost about 35USD-50USD. The item "4WD 60mm Mecanum Wheel Robot Car Chassis Kit with MG513 Encoder Motor Arduino DIY" is in sale since Monday, November 18, 2019.
This item is in the category "Business & Industrial\Industrial Automation & Motion Controls\Industrial Robotic Arms". The seller is "topskyrc" and is located in Shenzhen. This item can be shipped worldwide.