DIY Arduino UNO R3- Build Your Own Arduino

DIY Arduino UNO R3- Build Your Own Arduino
DIY Arduino UNO R3- Build Your Own Arduino
DIY Arduino UNO R3- Build Your Own Arduino
DIY Arduino UNO R3- Build Your Own Arduino
DIY Arduino UNO R3- Build Your Own Arduino
DIY Arduino UNO R3- Build Your Own Arduino
DIY Arduino UNO R3- Build Your Own Arduino
DIY Arduino UNO R3- Build Your Own Arduino
DIY Arduino UNO R3- Build Your Own Arduino

DIY Arduino UNO R3- Build Your Own Arduino
NOTE: IT is a Do-it-yourself (DIY) Kit. You will get all the components required to build your own Arduino. You will have to assemble it yourself. It is similar to the original Arduino UNO and works perfectly with any Arduino shields. You know that there are several versions of Arduino hardware. Hobbyists have also made Arduinos on strip boards giving different looks. Here's one more Arduino, that is a simple do-it-yourself (DIY) kit. It is just like any other Arduino UNO board. However, it does not have FT232RL chip, therefore, you would need a separate FTDI basic module to burn your sketch. This kit contains everything you need to build your very own Uno-compatible DIY Arduino board. Simply follow the Assembly Guide and after some basic soldering, youll have made a fully-functional Arduino-compatible development board. The included ATmega328 comes pre-loaded with the Optiboot bootloader so you dont have to worry about loading the firmware, simply solder it together, connect an FTDI Basic and load your favorite sketch using the Arduino IDE. After the board is assembled, it can be powered by an FTDI connection or a regulated 6-15VDC power supply connected to either the DC Barrel jack or the 2 pin screw terminal. It is compatible with any kind of Arduino shields. It works like the original Arduino UNO R3. You will need either an FTDI Basic breakout Board or FTDI cable to load code using the Arduino IDE.

1 x Arduino-Compatible plated through holes (PTH) Kit PCB. 1 x ATMega328 with Optiboot bootloader. 1 x L78L33 3.3V Voltage Regulator.

1 x 5mm Green LED. 1 x 5mm Red LED. 2 x 22pF Ceramic Capacitors. 5 x 0.1uF Ceramic Capacitors. 2 x 10uF Electrolytic Capacitors.

1 x LM7805 5V Regulator. 1 x Resettable Fuse PTC (300mA).

1 x 28-Pin DIP Socket (To seat your ATMega). 1 x Push Button Reset Switch. 2 x 6-Pin Female Headers. 2 x 8-Pin Female Headers.

1 x 6-Pin Right Angle Header (To connect your FTDI Basic). 1 x 0.1uF Capacitor. 1 x DC Barrel Jack. 1 x 2-pin screw terminal. 1 x 6 pin ICSP header. We will send you a card that will direct you to tutorials.

The item "DIY Arduino UNO R3- Build Your Own Arduino" is in sale since Wednesday, June 8, 2016. This item is in the category "Electronics\Other Electronics". The seller is "buildcircuit" and is located in Saint Marys. This item can be shipped to Australia, all countries in Europe, United States, Japan, Canada, Hong Kong, New Zealand.


DIY Arduino UNO R3- Build Your Own Arduino


Homepage  Links  Contact Us  Privacy Policy  Terms of service