Rated voltage of motor: 12V. Encoder: turn the wheel once, output 390 pulses (the tire can distinguish 0.23 ° rotation).Note:the car without suspension uses acrylic base plate, which can make the wheels slightly adaptive if it is a little soft. The car without suspension can't use aluminum alloy because if aluminum alloy is used as a rigid plate, there will be a wheel hanging in the air at 3 point direction , and the running effect of the car is very bad. 4 x 60mm Mecanum wheels. 4 x 12V DC motors with MG513 encoder. Not included any controller and battery. Unassembled kit, please leave your mailbox to get the installation manual. 4WD 60mm Mecanum Robot Suspension Platform Car Chassis Kit for Raspberry Pi. 4WD 60mm Mecanum Wheel Robot Car Chassis Kit 10Kg Load for Raspberry Pi DIY ht5. 4WD 80mm Mecanum Wheel Robot Car Chassis Kit w/DC 12V Encoder Motor DIY ht55.
DIY DC 4WD Smart Robot Car Chassis Kit With TT Motor 60mm Wheel For Arduino ht55. 4WD 60mm Mecanum Wheel Robot Car Chassis Kit w/ MG513 Encoder Motor DIY.Usually it cost about 35USD-50USD. The item "DIY 4WD 60mm Mecanum Wheel Robot Car Chassis Kit +Motor for Arduino Raspberry Pi" is in sale since Thursday, July 30, 2020.
This item is in the category "Business, Office & Industrial\Industrial Automation & Motion Controls\Drives & Starters\Drives & Motor Controls\Other Motor Controls". The seller is "onemoredeal" and is located in Shenzhen. This item can be shipped worldwide.